|Auto Switches
-
How do I set a D-MP□ series actuator position sensor using the teach pad?
-
The indicator light turns ON or flashes (flashes either slowly or rapidly) depending on the operation of the teach pad.
For setting instructions, refer to the “Settings” section in the D-MP series operation manual as well as the video below.
Double-click and hold the teach pad, and the pattern of blinking will change every 3 seconds. Remove your finger at the desired timing. (Various settings can be selected at once depending on when you remove your finger.)
Note) If the indicator does not flash, wait about 3 seconds and try double-clicking again.
The D-MP□ series operation manual can be found here.
And a video with the D-MP□ setting instructions can be seen here.
